MD-212R wireless rolling shutter magnetic switch manual

Meian tech Focus brand wireless smart home automatic burglar alarm, emergency alarm, remote monitor system for home security. How to program the wireless alarm system? Learn it here.
vedard
Posts: 700
Joined: Wed Dec 05, 2018 12:27 am

MD-212R wireless rolling shutter magnetic switch manual

Unread post by vedard »

Rolling door shutter wireless sensor for garage door, shop door. 120m wireless transmission distance high sensitivity. When the emitter and magnetism distance is more than 4cm, it trigers alarm and send out alarm signal to alarm control panel. It is used for rolling door to prevent intrusion from door.
Tamper switch, low power consumption with CR123 Lithium batery.
Auto report the operating status. Periodic report when rolling shutter is not well closed.
rolling door shutter installing.JPG
rolling door shutter installing.JPG (49.06 KiB) Viewed 2924 times
MD-212R.pdf
(305.42 KiB) Downloaded 323 times
Shop Focus brand wireless alarm, HB solar power alarm, HST fire alarm at https://www.vedardalarm.com
vedard
Posts: 700
Joined: Wed Dec 05, 2018 12:27 am

Install wireless door magnetic alarm sensor for rolling door

Unread post by vedard »

There is specific door magnetic alarm sensor for rolling door of garage and shops. When the rolling door is opened at arm status, the wireless door magnetic contact switch will contact with burglar alarm system, active siren strobe and send alarm information to registered alarm phones, security service center.
install rolling door wireless magnetic switch.jpg
install rolling door wireless magnetic switch.jpg (121.63 KiB) Viewed 2920 times
There are two parts of the rolling door magnetic alarm sensor. One part is magnet. Another part is the reed switch connected with emitter by steel pipe.
The magnet part must be fixed on the ground beam of the rolling door. To ensure that the magnetic force of the magnet is not masked, please leave a gap between ground beam and magnet head and end.
MD-212R.jpg
MD-212R.jpg (9.93 KiB) Viewed 2920 times
The reed switch must be fixed just below the fixed magnet. It can be fixed on ground or in ground below the fixed magnet. The distance between the magnet and the reed switch must be less than 2cm when the rolling door is closed. Refer to fig.
The wireless emitter must be fixed in the host communication distance. And it can not be fixed on the metal material. The steel pipe can be extended to meet the distance requirement.
As a conclusion, we would like to make a note for you.
1. Please leave a gap between magnet and ground beam of rolling door.
2. Please make sure the reed switch is fixed just below the magnet and the distance between each other is less than 2cm when rolling door is closed.
3. Please do not fix the wireless emitter on metal material.
Shop Focus brand wireless alarm, HB solar power alarm, HST fire alarm at https://www.vedardalarm.com
vedard
Posts: 700
Joined: Wed Dec 05, 2018 12:27 am

How to install roller shutter door sensor

Unread post by vedard »

Roller shutter door sensor is used for rolling gate for garage, shop or store etc. Rolling gate magnet can be wireless or wired connected with alarm control panel and linked with sounder and light or siren strobe.
The linkage security system will automatically trigger sound light alarm to scare theft and trigger security camera to take photo.
Prepared protection can minimize loss and injury.
Shop Focus brand wireless alarm, HB solar power alarm, HST fire alarm at https://www.vedardalarm.com
Post Reply