Addressable fire alarm control panel

[vedard]

Addressable fire alarm control panel works with printer, network communication card, repeater panel, smoke alarm, heat detector, gas sensor, manual call point, siren strobe. The complete alarm system can automatic trigger fire fighting system, and gas extinguisher, Exhaust fan for Smoke exhaust.

panel MN300.pdf

(1.77 MiB) Downloaded 1168 times

[vedard]

addressable-fire-alarm.jpg (116.54 KiB) Viewed 14516 times

[vedard]

fire alarm system.JPG (54.74 KiB) Viewed 14486 times

address fire alarm.JPG (63.21 KiB) Viewed 14485 times

[Jim]

How to add the bus-line short circuit isolators?
We make clear explain as below with diagrams.
Note:
1. We take smoke and heat detectors as examples in the picture.
Only the alarm bus-line is drawn and the power cord is omitted.
2. In Figure 3, the bus-line passes through the fire partitions, and if no equipment is connected in the fire partition, a short-circuit isolator may not be installed in the fire partition.The bus short-circuit isolator of annular structure can be arranged on the side of fire partition 1 or fire partition 2.
3. The number of address occupied by the bus short-circuit isolator products of some equipment manufacturers shall be calculated according to the nominal address number of equipment manufacturers.
4. The bus short-circuit isolator can be placed in the module box or installed near the wall along the road with the base distance of 2.2m.When installed in the ceiling, the bottom should be close to the ceiling 0.2m apart, and the ceiling should be repaired and marked clearly.Dendritic bus short-circuit isolators can also be centrally located in weak current silos.
5. Bus short-circuit isolators with ring structure and tree structure are generally not universal.
6. If the fire detector has its own isolation function, the bus short-circuit isolator can no longer be set up separately.
7. Whether the bus loop adopts tree structure or ring structure shall be determined by the designer and the corresponding products shall be selected and matched.

[vedard]

Commercial security and industry security addressable fire alarm system with LPCB certificate.
Content:
1. Automatic Fire Alarm System
2. Gas fire extinguishing control system
3. Graphic Display unit
4. Explosion-proof system
5. Intrinsically safe system
6. Combustible gas alarm control system
7. Aspirating Smoke Detection and alarm system
8. Smart safety home security system
9. Smart fire protection system

[Jim]

Instruction manual of input module
Use and operation Encoding operation: you can use our company's hand-held encoder to live coding. When encoding, connect the two clips of the encoder to the two terminals of the linkage, open the handheld encoder power, enter the address code to be written (address code range must be: 1-242, the address code for the same loop is unique). Press the "write code" button, if encoding is successful, the encoder will display the address number after sending the address code. If failed, the encoder will display “FAL” after sending the address code.For details on the steps and methods of encoding, refer to the " Handheld Encoder User's Manual".
F. Note 1. The alarm function test of smoke detector should be performed every six months. 2. When the controller detects the cleaning forecast, please send the number of smoke detectors back to the company for cleaning, in order to avoid false or false positives, resulting in unnecessary losses.

[vedard]

Hand held programmer is important device for addressable fire alarm system. With it, programming and reading code of addressable fire alarm system is easy.