Linkage of burglar alarm and video surveillance system

Business security, commercial security, hotel security, factory security, industry security solution.
vedard
Posts: 837
Joined: Wed Dec 05, 2018 12:27 am

Linkage of burglar alarm and video surveillance system

Unread post by vedard »

Larger security projects require the linkage of alarm system and video surveillance. But the anti-theft alarms and video surveillance equipment are made by different manufacturers.Their communication protocols are different.Therefore, a certain way is needed to set the linkage of these two devices. There are three linkage modes of burglar alarm and video surveillance system.
1.The linkage of alarm device and DVR/NVR (relay output signal linkage)
The alarm panel has 485 communication interface, it will send alarm data to linkage module when it receives alarm from wired and wireless detectors. The linkage module (always 32 channels) will be connected with DVR/NVR and transfer the alarm data to DVR/NVR (the DVR/NVR should have alarm linkage input interface). The linkage function can be set on the DVR/NVR software.
Image
Advantages: easy to connect with hard connection.
Shortage: linkages channels are limited to 32 or expanded to 64 only.
2.The linkage of alarm and network camera
The alarm host will communicate with alarm center when it receives alarm signal from wired or wireless detectors. (If the alarm host has GPRS or TCP/IP network, it can communicate with the alarm center directly. If the alarm host has no network but with 485 interface, it can connect with network module and communicate with alarm center.) Then the alarm center will communicate with the video surveillance server and ask for relative network camera video information. Then the required network camera video information will be got and displayed.
This kind of linkage is based on burglar alarm software, and the final linkage video is also reflected in the interface of anti-theft alarm software. Therefore, the other side needs to provide the SDK to access the network camera software for the development of anti-theft alarm manufacturers. The original video monitoring system is not used.
For example, No.1 alarm detector was linked with 8842 camera. Then when triggers No.1 alarm detector, it will send alarm signal to the alarm host, the alarm host will send to the alarm center software, the software will send to the camera server for obtaining 8842 camera video instructions, obtained 8842 camera video signal will go back to the center of the alarm software.
Shortage: Relative communicated.
Image
3.Linkage of alarm and network video server
The alarm host will communicate with video server and ask for relative network camera video information when it receives alarm signal from wireless or wired detectors. Then the obtained video information will be displayed on video alarm center.
Image
Shop Focus brand wireless alarm, HB solar power alarm, HST fire alarm at https://www.vedardalarm.com
Post Reply