How to wire fire automatic fighting system?
Posted: Fri Dec 21, 2018 10:47 am
How to wire Fire intelligent control panel with various fire detection, fire fighting, fire monitor device? There are various types of modules for the connection.
1. Short-Circuit-Isolator module. This module is used to temporarily isolate the fault detector, input-output module or call point etc. from the system. So, the fire alarm system can keep working properly without interruption.
2. Input module. There are two types input modules. One is to connect conventional type smoke heat detector, gas sensor, manual call point, hydrant button.
3. Output module. Output module is used to connect fire warning device such as ceiling speaker, wall speaker. According to drive current and voltage, there are various type output module and input/output module to connect with various types output device.
1. Short-Circuit-Isolator module. This module is used to temporarily isolate the fault detector, input-output module or call point etc. from the system. So, the fire alarm system can keep working properly without interruption.
- GL-957short-circuit-isolator.jpg (37.16 KiB) Viewed 7237 times
- JK-952input module.jpg (38.69 KiB) Viewed 7233 times
- JS-951input module.jpg (40.1 KiB) Viewed 7233 times