Page 1 of 1

SOLAR&WIRELESS BEAM SENSOR SERIES

Posted: Wed Jan 16, 2019 8:40 am
by vedard
Solar&Wireless Beam Sensor
Features:
◆ Battery Powered&Solar Charged,no need cables.
◆ Up to 100 meters easy detection range.
◆ 1 KM wireless transmission Range.
◆ Multiple Detection Beams(to avoid false alarm--such as falling leaves or birds).
◆ Automatic Shielding of the sunlight interference.
◆ No external cables and the antenna inside the shell,so will not be damaged by the lightening strike.
◆ Invalid reminder when the beams are not mounted well.
◆ Operating Range:-30°C to 70°C.
◆ Anti-interference,Using FSK+FHSS wireless transmission technology.
◆ 4/6/8 Beam Sensor has on-site alarm function.
1a.jpg
1a.jpg (112.57 KiB) Viewed 4173 times
Technical Parameters
Infrared Detection Range 100m
Wireless Transmission Range 1KM
Beam Quantity 2/3/4/6/8
Wireless Frequency 433MHz FSK+FHSS
Maximum Trigger Number In 24 Hours ≤200 times
Working Voltage 3.3V
Battery Type Chargeable LiFePO4 Battery
Battery Capacity Transmitter:500mAh Receiver: 500mAh
Static Working Current HB-T001Q2/Q3+/Q4≤0.5mA;
HB-T001Q6≤0.75mA;
HB-T001Q8≤1mA
Infrared Wavelength 940nm±20nm
Solar Panel Output Current 1800Lux illumination level:
HB-T001Q2/HB-T001Q3+≥2mA;
HB-T001Q4≥4mA;
HB-T001Q6≥6mA;
HB-T001Q8≥8mA
(Remarks: The outdoor illumination intensity on rainy days is about 2000Lux)
Working Temperature Range -30℃~70℃
Weight HB-T001Q2/Q3+:2.0kg
HB-T001Q4:3.0kg
HB-T001Q6:3.6kg
HB-T001Q8:4.8kg
Dimension HB-T001Q2/HB-T001Q3+:340×84×45(mm)
HB-T001Q4:590×84×45(mm)
HB-T001Q6:840×84×45(mm)
HB-T001Q8:1090×84×45(mm)
Solar beams sensor.jpg
Solar beams sensor.jpg (29.05 KiB) Viewed 4172 times
project-m.JPG
project-m.JPG (100.78 KiB) Viewed 4172 times

Re: SOLAR&WIRELESS BEAM SENSOR SERIES

Posted: Fri Feb 15, 2019 2:56 am
by vedard
How to install solar wireless alarm system? Why 4 beams, 6 beams, 8 beams infrared beam detector is needed?
Check attached video guidance for installing 4 beams, 6 beams, 8 beams photoelectric infrared beam sensor.
4, 6 or 8 beams can provide higher protection area. For high protection area such as bank, farm, garden, the solar beams are installed on the ground. So, the beam sensor will be fixed on the pole and then installed on the ground. 4, 6 or 8 beams can provide 60 cm or higher blocking height to prevent intrusion under the beam or above the beam.
T001 Q4&6&8.pdf
(2.08 MiB) Downloaded 595 times
4-beams solar alarm system installation guidance.mp4
(161.71 MiB) Downloaded 292 times