Page 1 of 1

Glass Break Detector FG-2035 Installation

Posted: Thu Jan 10, 2019 9:01 am
by vedard
FG-2035 Glass break detector can be installed on flush (single gang box) or surface wall/ ceiling. Both low frequency "flex" and high frequency "shatter" sound can be detected. It will detect the breaking of most common types of framde glass panes and with free false alarm. Minimum size for all types of glass: 30cm*30cm (12"*12")
Thickness plate: 3.2mm-6.4mm (1/8"-1/4") tempered. laminated wired 64 mm (1/4")
It will not alarm if glass pane broken from inside or glass dropped on floor.
FG-2035.pdf
(168.25 KiB) Downloaded 478 times

Glass Break Detector FG-2036R Installation

Posted: Tue Feb 12, 2019 8:36 am
by vedard
Home Security System Glass break detector Focus brand Alarm control panel compatible wireless security sensor and alarm accessory
Twin-stage potentiometer.
Built in audio analysis of microprocessor.
With anti-tamper function, networking alarm output.
Introduction
Twin-stage potentiometer.
Built in audio analysis of microprocessor.
With anti-tamper function, networking alarm output.
Working current: 12.5mA
Working voltage: 2*3V CR123 lithium battery supply
Response time:<20S

Glass Break Detector manual

Posted: Fri Jun 10, 2022 12:49 pm
by vedard
Acoustic glass break detector; To attach to the alarm control panel, it responds only to the sound of different types of glass breaking. can be installed at 7.6m maximum to farthest point of glass being protected. glass size over 0.3m plate, tempered, laminated, and wired glass. and 0.32cm plate glass. with adjustable sensitivity. Area of operation is 25ft (7.6m) from the farthest corer, for glass sizes 0.3m by 0.3m and larger. Vertical angle of detection not less than 75 degrees, horizontal angle not less than 90 degrees; With LED indication; Wired connection; Supply voltage 12 V, operating temperature range not more than -20C not less than + 50C; Size 115x72x27mm.
glass break sensor.jpg
glass break sensor.jpg (13.34 KiB) Viewed 1759 times