Page 1 of 1

Automatic Fire Alarm Control Panel software

Posted: Tue May 04, 2021 8:06 am
by vedard
Annotation and linkage programming software can be run on win7, win8 or win10 Microsoft .NET Framework 4.5.
From the CMS, you can create project and add the FACP with all its sub-system. The steps are as below:
1. add loop and edit loop quantity, loop number and loop name.
2. Add controller zone and edit zone name.
3. add partition and add zones to the partition.
4. Adjust sensitivity of smoke detector, gas sensor, heat detector.
5. Set time delay for I/O module, fire alarm module etc.
6. Linkage programming. Add the linkage output device and dedicate line device. Add linkage programming alarm area.
7. The programmed file can be saved as backup and be input next time.