Page 1 of 1

Installation notes for solar wireless beam

Posted: Mon Mar 16, 2020 3:09 am
by vedard
1. The solar wireless beam should be installed outdoor.
2. The solar wireless beam should not be installed at dark place. If the maximum illumination of the installed place is less than 2000LX during the day, external power cord should be connected.
3. The solar wireless beam is not suitable for use in places such as gate passageway where the alarm is triggered more than 20 times a day. But there is low power comsumption outdoor detector such as HB-T704 and HB-T705 can be used.
4. In order to enable infrared light to send to longer distance, this product is designed with a smaller Angle of light, so it needs to be more accurate in light matching during installation, and the mounting bracket is required to be firm and not shaken, otherwise it may cause failure. You can use laser pointer to calibrate the beams.

-

Posted: Mon Aug 02, 2021 11:04 pm
by RaSFal
we have the code to enter at the specials menu, but we do not know where on the specials menu to enter this code and how do you enter letters. Thanks for the patience, this is all new to us.

Re: about the code of solar beam and detector

Posted: Tue Aug 03, 2021 8:02 am
by vedard
RaSFal wrote: Mon Aug 02, 2021 11:04 pm we have the code to enter at the specials menu, but we do not know where on the specials menu to enter this code and how do you enter letters. Thanks for the patience, this is all new to us.
Hi! Yes, each detector has a code. And the detector should be learned into the alarm panel. So, when the detector triggers alarm, the alarm panel will receive it and send out report to mobile phone, security service center etc.
About how to enter this code, please refer to relative alarm panel or receiver manual. Follow the steps of learning a detector. It may not need to enter the code but trigger the detector at learning detector step.