Page 1 of 1

The solar beam can not be enrolled with alarm panel

Posted: Wed Jun 26, 2019 8:29 am
by vedard
The solar beam can not be enrolled with alarm panel. What is the problem?
Please check whether or not the receiver terminal (S) alarm led indicator is lit up when all infrared holes are blocked. (At the step of enroll with alarm panel).
1. If the led is lit up, but can not enroll with alarm panel, then it is problem of the solar beam or alarm panel. Replace a panel or wireless device such as door contact, remote controller or PIR, emergency button to check.
2. If the led is not lit up, that means no signal is sent. Cause 1. One or both terminals are not powered on. Need to press the power on button and keep for a while to ensure it is powered on. Cause 2. The battery voltage is low and can not work after power on. If so, need to charge the battery in a sunny place.