Vedard Security Alarm Technical Support

6. Input output module for fire lift 7. Input output module for solenoid valve types device 8. Multi-line control unit

KZ-953output module.jpg 4. Input output module for non-fire-elevator KZJ-956input-output module (for non-fire-elevator).jpg 5. Input output module for rolling door control KZJ-956input-output module (for rolling door control).jpg 6. Input output module for fire lift KZJ-956input-output module (for ...

Connect FC-7416 to the second group of RBGY on main board (2nd group RBGY is for programming keypad)

Use FC-32 relay out module to connect FC-7448 with CCTV NVR and get image pop up when alarm occurs.

FC-4010 can not communicate with PC, why?
Please make sure the connection is correct. FC-4010 should be connected to the first group RBGY on the main board. Then make sure programming is right. It is 4019 18# then 4020 40#

Function: If the door is open, the access control will send switch signal to FC-7448, FC-7448 will dial out for voice alarm to preset phone number and CID security center. Solution: Use FC-7448 address module to connect access control panel to FC-7448. So, the door open signal will send to FC-7448 a...

Using address module FC-7401 to wire infrared beam to bus zone FC-7448. It showed zone is not ready but the beam transmission and receiver is aimed. What is wrong? Change an address module to test. If problem still exists, then the beam is with problem. How to find the problem of the beam sensor? Po...

The alarm control panel can be armed/disarmed after programming finished. But after a while, it showed system is not ready and can not be armed/disarmed. Why? After programming, the system will enter into self inspection process. At this time, fault may be not found, so, it can be armed /disarmed. B...

FC-7448 is bus zone large capacity of burglar alarm, fire alarm control panel. 248 zones are available for monitoring and 2.4 km distance for communication. If you have set bypass zone and now you want to cancel it. Then you should just repeat the bypass step again. That is press "bypass"+...

Active photoelectric infrared detector beam system is most used for perimeter security protection. It works as first place anti-theft residential security and commercial security. The beam system consists of transmitter beam and receive beam and builds up an invisible barrier on wall, balcony, yard....